How to operate the Pocket Controller

Functionality

Use the menu to access the different features of the Pocket Controller. They are labeled as following:

EDIT CUSTOM

This is where the customizable parameter set can be customized. The built-in parameter sets can not be changed.

SELECT PARAMETER

Use LEFT/RIGHT to select which custom parameter you want to change.

CC

The CC number for the parameter on your synth.

NAME

Press SELECT to cycle through which character is edited. Press LEFT/RIGHT to change that character. All characters start at 'A', and you can go RIGHT for the other letters, and LEFT for symbols and numbers.

DEF

Default value. For most parameters it is 0, but for things like balance it might be the middle value (63).

GRANUL

The granularity of the possible values. For most parameters, it should be all the 127 possible values (continuous). But some things like "oscillator type" might only have a limited set of possible values. I.e. a granularity of 5 will divide and visualize the value range into 5 parts.

SYNTH

Here the current parameter set can be changed. There are some built-in sets for popular synths, and a custom one that you can define yourself in EDIT CUSTOM.

ENVELOPE

These are settings for an envelope generator that can be triggered externally and map to any output parameter.

ENABLE

Enable or disable the triggering of the envelope generator on incoming NOTE ON.

TARGET

The CC number for the parameter that the envelope modifies.

TYPE

Envelope can be attack-decay-sustain-release (ADSR) or simply attack-release (AR).

ATTACK, DECAY, SUST, RELE

These are the familiar parameters of each phase of an envelope: It starts with an attack time, shortly followed by decay time to a sustain level (not a time) and ends with a release time.

BOTTOM, TOP

The relative values (0-100 %) that the envelope uses as the minimum and maximum. Normal envelopes go between 0 and 100 %. But it is possible to narrow that, and also to flip the direction of the envelope by using a maximum higher than a minimum.

START

Enable or disable restarting the entire envelope when a new note is triggered before the envelope is finished.

DRONE

Here you can toggle on/off the continuous drone, and change it's note. Pressing BACK when outside of the menu is also a hot key for toggling the drone.

SYSTEM

These are system settings like MIDI channel, MIDI thru and screen brightness.